We use certified instruments for high-accuracy electrical testing:
1664 FC Installation Multifunction Tester
- Insulation testing up to 1 kV DC
- Measurement of AC voltage, insulation resistance, loop and line impedance (ZI)
- Measurement of prospective earth fault current, tripping speed, earth resistance, and RCD/FI tripping current
- Continuity testing, RCD testing, and ramp testing
- Earth Volt Touchpad detects high earth voltage
- Cat III to 500V, Cat IV to 300V Safety ratings
1625-2 GEO Earth Ground Tester
- Accurate earth ground testing using all four test methods
- Measures earth ground loop resistances using only clamps, only stakes, or one clamp and stakes With the stakeless test method, measures earth ground loop resistances for multi-grounded systems using only current clamps
375 FC True-RMS AC/DC Clamp Meter
- Measures AC and DC current to 600 A and voltage up to 1000 V with the fixed jaw clamp
MIT2500 High Voltage Handheld Insulation and Continuity Tester
- Insulation testing up to 2.5 kV and 200 GΩ range
- Adjustable insulation test voltage from 50 V to 2500 V
- Stabilized insulation test voltage
- Single range, faster continuity testing from 0.01 Ω to 1 MΩ
- Polarization Index (PI) and Dielectric Absorption Ratio (DAR)
- CAT IV 600 V applications
IRC130 Thermal Imager IR Thermometer with MSX
Thermal Imager IR Thermometer with MSX is a powerful diagnosing tool, providing access to a spectrum of imagery otherwise inaccessible to the naked eye
EA20 EasyView Hygro-Thermometer
- Monitor Relative Humidity and Temperature in factories, clean rooms, offices, and greenhouses
- Produce reports of overnight or long-term humidity and temperature fluctuations
6201 Smoke, Heat and CO Detector Test and Removal Kit
Smoke, heat and CO generated on-demand Activation of the widest range of smoke and heat sensors (up to 100°C) Uses non-hazardous smoke & CO capsules Features clearing mode to eliminate re-alarms
601B Battery Capacity Analyzer
Addresses the need to test and maintain sealed lead acid (SLA) batteries used in backup power UPS, emergency lighting, fire alarms, security systems, and many other electrical systems. By quickly characterizing a battery's response to a load resistance and measuring the battery's internal resistance, this meter displays the remaining battery capacity as an indicator of the battery's health. Powered by the battery under test, the 601B supports testing of both 6V and 12V batteries.
LinkIQ™ Cable+Network Tester
- Validate Cable Performance up to 10GBASE-T via frequencybased measurements
- Get connected switch data rate, switch name, IP address, port number, and VLAN
- Detect the PoE class (1-8) and power, and perform a load test
- Test connectivity to TCP/IP network through IP configuration and ping
- Manage results and print reports from LinkWare™ PC